RCBS Coated Neck Bushings are interchangeable to let the reloader select a bushing that gives precisely the right amount of tension on the bullet when using RCBS Gold Medal Match neck sizing dies. These bushings have a Tungsten Disulfide (WS2) anti-friction coating, so they do not require use to traditional case lube. Self-centering for proper alignment with case neck For best results, use of high-end brass with consistent neck thicknesses For use ONLY with RCBS Gold Medal neck sizing dies RCBS recommends having neck bushings one to two sizes above and below your target diameter (see note below). RCBS Coated Neck Bushings are a small but critical component in loading extremely consistent-shooting ammo with your Gold Medal Match sizing dies. Brownells Gun Tech™ Tip: There are two ways to select the steel neck bushings you need: (1) Measure the outside neck diameter of your loaded cartridge and subtract .002" to .003". This allows approximately .001" of brass to spring back for correct neck tension. (2) You can also measure the neck wall thickness of your case, multiply by two, add the diameter of your bullet and subtract .002" to .003".
Vylepšete svou přesnost s TUNGSTEN COATED NECK SIZING BUSHING
RCBS Coated Neck Bushings jsou navrženy tak, aby umožnily přebíječům vybrat bushing, který poskytuje přesně takové napětí na projektil, jaké je potřeba při použití RCBS Gold Medal Match neck sizing dies. Tyto bushingy mají povlak z Tungsten Disulfide (WS2), což znamená, že nevyžadují použití tradičního lubrikantu pro náboje.
Vlastnosti produktu:
- Samocentrování pro správné zarovnání s nábojem
- Pro nejlepší výsledky používejte kvalitní mosaz s konzistentní tloušťkou krčku
- Pouze pro použití s RCBS Gold Medal neck sizing dies
- RCBS doporučuje mít neck bushings o jednu až dvě velikosti nad a pod cílovým průměrem
RCBS Coated Neck Bushings jsou malou, ale zásadní součástí při nabíjení extrémně konzistentních nábojů s vašimi Gold Medal Match sizing dies.
Tip od Brownells Gun Tech™:
Existují dva způsoby, jak vybrat ocelové neck bushings, které potřebujete:
- 1. Změřte vnější průměr krčku vašeho nabitého náboje a odečtěte .002" až .003". To umožňuje přibližně .001" mosazi, aby se vrátila zpět pro správné napětí krčku.
- 2. Můžete také změřit tloušťku stěny krčku vašeho náboje, vynásobit dvěma, přidat průměr vašeho projektilu a odečíst .002" až .003".